|
Specification |
|
Fixed port |
Twenty-Four 100/1000Base-X ports |
|
Forwarding performance |
96 Mpps |
|
Extended slot |
Provide one extended slot. |
|
MAC address table |
IEEE 802.1d compliance |
|
32K MAC address entries |
|
MAC address learning and aging |
|
Static, dynamic, and blackhole MAC address entries |
|
Packet filtering based on source MAC addresses |
|
VLAN |
4K VLANs |
|
Guest VLAN and voice VLAN |
|
VLAN assignment based on MAC addresses, protocols, IP subnets, policies, and ports |
|
1:1 and N:1 VLAN Mapping |
|
GVRP, MUX VLAN |
|
Reliability |
RRPP ring topology and RRPP multi-instance |
|
Smart Link tree topology and Smart Link multi-instance, providing the millisecond-level protection switchover |
|
SEP |
|
ERPS(G.8032）(supported by the S5700-LI/S5700-SI/S5700-EI/S5700-HI series) |
|
STP, RSTP, and MSTP |
|
BPDU protection, root protection, and loop protection |
|
BFD for OSPF, BFD for IS-IS, BFD for VRRP, and BFD for PIM |
|
IP routing |
Static routing, RIPv1, RIPv2, OSPF, IS-IS, BGP, and ECMP |
|
IPv6 features |
Neighbor Discovery (ND) |
|
Path MTU (PMTU) |
|
IPv6 ping, IPv6 tracert, and IPv6 Telnet |
|
ACLs based on the source IPv6 address, destination IPv6 address, Layer 4 ports, or protocol type |
|
MLD v1/v2 snooping |
|
6to4 tunnel, ISATAP tunnel, and manually configured tunnel |
|
Multicast |
IGMP v1/v2/v3 snooping and IGMP fast leave |
|
Multicast forwarding in a VLAN and multicast replication between VLANs |
|
Multicast load balancing among member ports of a trunk |
|
Controllable multicast, MLD v1/v2 snooping |
|
Port-based multicast traffic statistics |
|
IGMP v1/v2/v3, PIM-SM, PIM-DM, PIM-SSM, MSDP (supported by the S5700-EI/S5700-HI series) |
|
QoS/ACL |
Rate limiting on packets sent and received by an interface |
|
Packet redirection |
|
Port-based traffic policing and two-rate three-color CAR |
|
Eight queues on each port |
|
WRR, DRR, SP, WRR+SP, and DRR+SP queue scheduling algorithms |
|
WRED (supported by the S5710-EI and S5700-HI) |
|
Re-marking of the 802.1p priority and DSCP priority |
|
Packet filtering at Layers 2 through 4, filtering out invalid frames based on the source MAC address, destination MAC address, source IP address, destination IP address, port number, protocol type, and VLAN ID |
|
Rate limiting in each queue and traffic shaping on ports |
|
Security |
User privilege management and password protection |
|
DoS attack defense, ARP attack defense, and ICMP attack defense |
|
Binding of the IP address, MAC address, interface, and VLAN |
|
Port isolation, port security, and sticky MAC |
|
Blackhole MAC address entries |
|
Limit on the number of learned MAC addresses |
|
802.1x authentication and limit on the number of users on an interface |
|
AAA authentication, RADIUS authentication, HWTACACS authentication, and NAC |
|
SSH v2.0 |
|
Hypertext Transfer Protocol Secure (HTTPS) |
|
CPU defense |
|
Blacklist and whitelist |
|
OAM |
Hardware OAM:
EFM OAM
CFM OAM
Y.1731 performance test (hardware-level delay and jitter detection)
|
|
Management and maintenance |
MAC Forced Forwarding (MFF) |
|
Virtual cable test |
|
SNMP v1/v2c/v3 |
|
RMON |
|
Web-based NMS |
|
System logs and alarms of different levels |
|
802.3az EEE |
|
sFlow |
|
NetStream |
|
Dying Gasp |
|
Interoperability |
Supports VBST (Compatible with PVST/PVST+/RPVST) |
|
Supports LNP (Similar to DTP) |
|
Supports VCMP (Similar to VTP) |
|
Input DC voltage: Rated input voltage range |
-48 V DC to -60 V DC |
|
Input DC voltage: Maximum voltage range |
-36 V DC to -72 V DC |
|
Input AC voltage: Rated input voltage range |
100 V AC to 240 V AC, 50/60 Hz |
|
Input AC voltage: Maximum voltage range |
90 V AC to 264 V AC, 47 Hz to 63 Hz |
|
Operating temperature |
0°C to 50°C |
|
Relative humidity |
5% RH to 95% RH, noncondensing |
|
Dimensions (W x D x H) |
442.0 mm x 420.0 mm x 43.6 mm |
|
Power consumption |
< 80 W |
